220V single-phase vibrating sieve with diameter 400mm

single-phase vibrating sieve
the screen of 220V vibrating sieve
The spring of single-phase vibrating sieve

Manual Mixing:

220V single-phase vibrating sieve is mounted with 0.18kw vertical vibrating motor.There are the diameter of 400mm,one layer screen mesh with two dischange holes.Mainly used in screening material with high output.Accept customized service.

►Introduction and working principle
220V single-phase vibrating sieve is designed as a high-precision screening machinery.DH series circle vibrating sieve is a vertical-motor system, with eccentric hammers being installed on top and bottom of the machine,where the vibration motor acts as the vibratory source.The direction of the eccentric hammers may change its rotational mode either in horizontal,vertical and inclined movement onto the sieving screener surface.
 
►Features
1.  Widely used in any powder and liquid material;
2.  Easy to change mesh, convenient to clean the mesh;
3.  Dust-proof ;
4.  Mesh size could be 2~1000 mesh or 0.013mm~8mm;
5.  Little volume, easy to install according to requirement;
6.  Max. 5 layers, 3 layers is better;
7.  Carbon steel , stainless steel material or customized material;
8.  Little power consumption, energy conservation and environmental protection, and can be installed indoor or outdoor;
►the detail of Manufacturing
  
►Use and maintenance
1, the machine shall be equipped with electrical protection device.
2, the machine is running early, check every day at least once a bolt to prevent loosening.
3, when the motor direction of rotation does not meet the requirements, you can adjust the power supply phase sequence.
4, the motor should guarantee good lubrication, each running about two weeks to add lithium grease (ZL-3) once, come on, through the oil by adding appropriate amount of lithium grease cup.
5, the machine running total of 1500 hours, check the bearings, if serious injury should be immediately replaced.
6, the machine parked or garaged when used again after a long time, measure the insulatio n resistance should be used to measure 500-volt megger.

likeproduct